Table of Contents
Advertisement
ENTRY/CLIP ➝ LIST/PF2 button
9.
ENTRY button
During clip playback or control of an external device,
press the IN or OUT button simultaneous with this
button to set an IN or OUT point.
CLIP ➝ LIST (SHIFT + ENTRY) button
Clip load function
➝Refer to "Buttons Used in Playlist Operations" (page
88).
PF2 button
In recording/playback mode, press this button after
pressing the PF button to start the setup menu
operation registered in the PF2 button.
10.
TRIM + /SLOT SELECT + button
SLOT SELECT + (SHIFT + TRIM+) button
Hold down the SHIFT button and this button
simultaneously to move to the previous recording slot
position. Pressing this button when the unit is in slot 6
results in a move to slot 1.
TRIM + button
Use this button to move to a hard disk partition.
➝Refer to "Displaying Clip Thumbnails on a Hard Disk"
(page 132).
Use this function for trimming.
➝Refer to "Buttons Used in Playlist Operations" (page
88).
11.
OUT/ALL CLIP/PF3 button
OUT button
Use this button to perform the following functions
during clip playback or when the unit is controlled
externally.
• OUT + ENTRY
Press the ENTRY button and this button to set an
OUT point.
• OUT
Press this button to confirm a set OUT point.
"--:--:--:--" is displayed when no point has been set.
• OUT + RESET
Press the RESET button and this button
simultaneously to delete the current OUT point.
• OUT + GOTO
Press the GOTO button and this button
simultaneously to cue up to the set OUT point.
ALL CLIP (SHIFT + OUT) button
In the thumbnail screen, press the SHIFT button and
this button simultaneously to return the clip display to
ALL.
26
Introduction: Control Reference Guide
PF3 button
In recording/playback mode, press this button after
pressing the PF button to start the setup menu
operation registered in the PF3 button.
12.
SHIFT/PF4 button
SHIFT
Use this button together with the FF, REW and SET
buttons (short cut keys).
➝Refer to "List of Shortcuts" (page 217).
PF4
In recording/playback mode, press this button after
pressing the PF button to start the setup menu
operation registered in the PF4 button.
13.
PLAYER/ SOURCE SELECT button
PLAYER button
Use this button to control an external device or operate
a player in playlist mode.
• In modes other than thumbnail or playlist mode:
Switches to operation of an external device
(RS-422A). Pressing PLAY or other operation button
will remote control an external device and display
externally input video, audio and time code.
• In playlist mode:
Switches to player/recorder.
➝Refer to "Preparing for Playlist Creation" (page
92), "Buttons Used in Playlist Operations" (page
88).
SOURCE SELECT (SHIFT + PLAYER) button
• In recording/playback mode:
Switches to operation of an IEEE1394 connected
device.
• In playlist mode:
Sets the source (interface) used as a player.
➝Refer to "Playlist Function" (page 80).
14.
GO TO/ A.DUB MODE button
GO TO button
Hold down this button and press the IN/OUT button to
cue up to an IN or OUT point.
In recording/playback or playlist mode, hold down this
button and press the TRIM(+)/TRIM(–) button to
perform frame advance.
➝For details on the playlist mode, refer to "GO TO/
A.DUB MODE button" (page 90)
Advertisement
Table of Contents
