Table of Contents
Advertisement
Item
FR
SUPER
No.
DISP.
148
WFM POS.
155
AUTO REC
160
REPEAT PLAY
165
CLIPSEL MODE
178
Setup: Item Settings
Setting
FR
SUPER
No.
DISP.
0000
RT
Selects the position for the waveform monitor.
0001
0: Top right
LT
0002
1: Top left
RB
0003
2: Bottom right
LB
3: Bottom left
0000
OFF
Select whether recording and stopping should be performed automatically according to
the recording/stopping signals in the HD SDI input signals from Panasonic camera-
0001
TYPE1
recorders.
0002
TYPE2
0: No automatic recording/stopping
0003
TYPE3
1: Recording and stopping is performed automatically according to the recording/
stopping signals in the LTC information attached to HD SDI signals.
2: Recording and stopping is performed automatically according to the recording/
stopping signals in the SVITC information attached to HD SDI signals.
3: Set when other manufacturer's camera-recorders are used.
NOTE:
• When the thumbnail screen or playlist screen is displayed, this setting is disabled and
has no effect.
• Set the CONTROL switch to REMOTE.
Refer to "Panasonic camera-recorders, recording formats and recording/stopping
signals (Recording Mark)" (page 179) before selecting TYPE1 or TYPE2.
• To start automatic recording, press the REC and STILL buttons simultaneously to
place this unit in REC PAUSE mode. Automatic recording does not start any mode
other than REC PAUSE mode. The unit returns to REC PAUSE mode when automatic
stop is activated.
• In normal recording mode, this setting is not available and auto stop is not activated.
• For the devices verified as TYPE3 devices, visit the following Web site:
For English: http://panasonic.biz/sav/autorec_e
0000
OFF
Determines whether or not to engage repeat play during playback.
0: Does not engage repeat play. Stops playback at the end of the last clip.
0001
ON
1: Engages repeat play. Continues playback from the beginning when reaching the end
of the last clip.
NOTE:
• Repeat play is not available when the PLAYLIST button is on and during TEXT MEMO
playback.
• If the P2 card is removed during repeat play, playback is suspended when playback
reaches the clip that is no longer exists.
• Even if you insert a P2 card during repeat play, additional clips are not played back
until you once stop repeat play and resume it.
• Always OFF when setup menu No. 27 (VDCP CMD) is ON.
0000
TOP
59.94Hz
0001
THUMB
Selects position of clip displayed by clip select.
0: Uses the first frame of the clip to select clips.
1: Uses clip thumbnail position to select clips.
NOTE:
This is a setting for control from the REMOTE connector.
Settings and brief function description
only
50Hz
Advertisement
Table of Contents
