Viessmann Vitocal 242-S Installation And Service Instructions Manual page 8

Preparing for installation
Requirements regarding on-site connections
C DHW circulation
D Opening for 230 V cables
E Cold water
F Liquid line
G Hot gas line
Connection sizes for hydraulic connections
Pos. Sym- Meaning
bol
B – DHW
C – DHW circulation
E – Cold water
F Refrigerant lines from/to
the external unit:
■ Liquid line
G ■ Hot gas line
H Heating water flow
K Heating water return
L
– Solar circuit return
M – Solar circuit flow
1. Prepare the connections on the heat-
ing water and the DHW side.
Flush the heating system.
8
(cont.)
H Heating water flow
K Heating water return
L Solar circuit return
M Solar circuit flow
Connection
7 connection pipe:
(supplied pipe bends)
UNF thread:
For type AWT-AC 241.A04, a reduction
from 10 to 6 mm is necessary down-
stream of the pipe bend (reducer ⅝ to ⁷⁄₁₆
supplied).
7 connection pipe:
(supplied pipe bends)
UNF thread:
For type AWT-AC 241.A04, a reduction
from 16 to 10 mm is necessary down-
stream of the pipe bend (reducer ⅞ to
¾ supplied).
DN 20 pipe sleeve for multi connect sys-
2. Prepare the electrical connections.
Rp ¾
G 1
Rp ¾
10 mm
⅝
16 mm
⅞
Cu 28 x 1 mm
Cu 28 x 1 mm
tem