Panasonic AW-HE130W Operating Instructions Manual page 108

Displaying the web screen using a mobile terminal (continued)
Camera menu (OSD menu) operation
When this button is pressed, the buttons for performing the camera
menu operations are displayed on the screen.
At the same time, the camera menus are displayed on the unit's
images.
The unit's camera menu operations can be performed by
pressing the ,
When any of these buttons is pressed to switch to an
operation that does not involve a camera menu, the camera
menus are no longer displayed on the unit's images.
For details of the camera menu, refer to page @@.
Tally lamp lighting status displays
The lighting status of the camera's tally lamp is monitored at regular
intervals while the camera is connected, and the lamp's display is
updated.
While the tally lamp is on, the IP video display area frame turns red.
When the tally lamp is off, the display area will return to normal.
<NOTE>
• It may take 2 seconds or so for a change in the lighting status of the
tally lamp to be reflected on the display of the mobile terminal.
• When [Disable] is selected for [Tally Enable] (→page @@, page
@@), the camera's tally lamp will not light even when the tally
signal is input. However, the area frame of the main area (IP video
display area) will turn red.
• If the HTTP port number has been changed from "80", enter
"http://<IP address>:<port number>/mobile"
port number.
• When the authentication dialog box appears, enter the user name
and password of an administrator or general user.
Depending on the mobile terminal, password entry may be required
when transitioning between each screen.
• If the [User auth.] (→ page @@) setting has been changed to
[On] from a personal computer while the mobile terminal screen
is displayed, it may not be possible to refresh the mobile terminal
screen. In a case like this, first close the web browser which is
running on the mobile terminal, and then open the mobile terminal
screen again.
• If the images are large, it may not be possible to display them on
some mobile terminals. In a case like this, it may be possible to
display the images if a setting close to low image quality is selected
for "Image quality" (→ page @@) of the "JPEG image settings"
among the "Video over IP".
• Access may not be possible depending on your mobile terminal and
device plans.
108
, and buttons.
to specify the unit's
1
*
• If, when using an Android terminal, more than one button is pressed
at the same time, one of the buttons may remain pressed even after
it has been released. At a time like this, press again only that button
that has remained pressed to release it.
Example) W hen the pan (left) button and pan (right) button are
pressed at the same time, either the pan (left) button or
pan (right) button will remain pressed, and panning will
continue.
→ W hen the pan (left) button or pan (right) button that has
remained pressed is pressed again, the panning will stop.
*
1
This IP address is the global IP address for the WAN of the router
that enables internet access.
However, it is the local IP address if the unit in the same LAN is
to be accessed using a mobile terminal which supports a wireless
connection.