Table of Contents
Advertisement
5.7.3. Transmitting data
After the pairing procedure, the Suunto D9tx will receive cylinder pressure data from
the transmitter. The pressure is displayed in either bars or psi, depending on the unit
selected. Any time the Suunto D9tx receives an appropriate signal, a flash symbol is
displayed in the lower left corner.
Table 5.4. Pressure transmission related displays
Display
Indication
Set Code. No code stored, Suunto D9tx ready for pairing with
Cd:--
transmitter.
Set Code. Code number can be between 01–32.
Cd:10
Pressure reading over 360 bar/5220 psi.
- - -
Pressure reading has not been updated for more than one minute.
no conn
The latest valid pressure reading is displayed intermittently.
Transmitter is out of range, in power saving mode or on another
channel. Activate the transmitter by breathing off the regulator,
and assign a new code to the Suunto D9tx unit if necessary.
Pressure transmitter battery voltage is low. The pressure reading
batt
is displayed intermittently. Change the transmitter battery!
Figure
A
B
C
D
E
47
Advertisement
Table of Contents
