Table of Contents
Advertisement
Ensure that the transmitter is properly attached to the regulator's HP port and
1.
that the regulator is properly attached to the cylinder.
Ensure that the Suunto D9tx is turned on, and that the wireless integration is en-
2.
abled in the Suunto D9tx settings (Tank Press is set ON. For more information,
refer to Section 5.8.3. Setting the tank pressure pairing). If the Suunto D9tx is in
the TIME mode, enter the DIVE mode by short-pressing the MODE button. The
D9tx should display "cd:--" in the lower left corner of the display.
Slowly open the cylinder valve fully and pressurize the system. The transmitter
3.
starts transmitting when the pressure exceeds 15 bar/300 psi.
Take the Suunto D9tx unit close to the transmitter. The unit will then quickly display
4.
the selected code number and then start displaying the transmitted cylinder
pressure. The wireless transmitter indicator (flash symbol) is displayed every time
the Suunto D9tx receives a valid signal.
WARNING
To assign a new transmitter code:
Slowly open the cylinder valve fully to pressurize the system.
1.
Close the valve. Depressurize the regulator so that the pressure is reduced to
2.
less than 10 bar/145 psi. Wait about 10 seconds, and slowly open the cylinder
valve again to re-pressurize to above 15 bar/300 psi.
The transmitter assigns a new code automatically.
If there are several divers using Suunto D9tx with wireless trans-
mission, always ensure that each diver is using a different code
before starting the dive. In case there are several divers using
the same code, the transmitter's code must be changed before
diving.
45
Advertisement
Table of Contents
