Setting Originals - Toshiba E-STUDIO 3511 Operator's Manual

Setting Originals

When Setting Originals on the Glass
Originals are sent in the order they are placed on the original glass in both the memory TX and direct TX
modes.
1
Raise the Reversing Automatic Document
Feeder, place the original (A) with its face
down on the glass.
- Raise it 60 degrees or more to detect the original.
2
Align the original against the left inner
corner of the glass.
- Different size originals can also be sent in one transmission.
- When LD, LG, LT-R, ST, COMP, A3, A4-R, A5, B4, B5 or FOLIO
originals are placed as shown in the figure on the right, the pre-
entered sender information is printed in the shaded position
shown (B) in the figure and sent to the remote Fax.
- Entering the sender information "2.REGISTERING THE
TERMINAL ID"
- When transmitting non-standard-sized originals, best results are
obtained by placing the originals horizontally on the glass.
- When LT, ST-R, A4, A5-R or B5-R originals are placed as shown
in the figure on the right, the pre-entered sender information is
printed in the shaded position shown (C) in the figure and sent to
the remote Fax.
3
Lower the Reversing Automatic
Document Feeder slowly.
Page 142
2
( A )
( B )
( C )
29