Toshiba E-STUDIO 3511 Operator's Manual page 35

- Quality TX:
Set whether or not to specify Quality TX.
ON, OFF
* This function makes the communication less affected by line condition when transmitting document to
overseas. When this mode is set to "ON", originals are sent at a slower speed than normal.
- Line:
Specify the line to be used when you send the original (with the 2nd line board attached) "4.2ND LINE
BOARD (OPTIONAL) INSTALLATION"
OFF, LINE1, LINE2
- SUB/SEP, SID/PWD:
Input the sub-address when the remote Fax you are communicating with needs a sub-address. Sub-
address is divided into the following categories.
SUB (sub-address): Entering information
SEP (selective polling address): Retrieving information
SID (sender identification): Password for SUB
PWD (password): Password for SEP
* Up to 20 digits of information can be stored for each of these sub-addresses.
When you send documents, you can specify a sub-address or password compatible with ITU-T
(International Telecommunications Union Telecommunications) standards.
* To use this function, the remote Fax must be capable of setting an ITU-T compatible sub-address or
password. For details, contact your nearest Toshiba Service Center.
- Subject, Body:
Subject and body can be added when using the Internet Fax function.
* When you send multi-page originals by placing them on the Reversing Automatic Document Feeder, you
cannot change the scanning conditions for each page.When originals are placed on the original glass,
you can change the following scanning conditions for each page. "Setting the Scanning Conditions for
Each Page" Page 37
Resolution Image quality mode
Exposure Original size
* Changing the default settings (HOME POSITION) when sending originals. "1.SETTING THE INITIAL
TRANSMISSION MODE"
Page 149
Page 140
2
33