Figure 14-5 Menu 23.1 - System Password - ZyXEL Communications VES-1000 Series User Manual

Enter your new system password and press [ENTER].
3.
Re-type your new system password for confirmation and press [ENTER].
4.
14.6.1 Resetting the VES
If you forget your password or cannot access the VES, you will need to reload the factory-default configuration file.
Uploading this configuration file replaces the current configuration file with the factory-default configuration file.
This means that you will lose all configurations that you had previously and the speed of the console port will be
reset to the default of 9600bps with 8 data bit, no parity, one stop bit and flow control set to none. The password
will also be reset to "1234" and the IP address to 192.168.1.1.
To obtain the default configuration file, download it from the ZyXEL FTP site, unzip it and save it in a folder. Turn
the VES off and then on to begin a session. When you turn on the VES again you will see the initial screen. When
you see the message "Press any key to enter Debug Mode within 3 seconds" press any key to enter debug mode.
To upload the configuration file, do the following:
1. Type atlc after the Enter Debug Mode message.
2. Wait for the Starting XMODEM upload message before activating XMODEM upload on your terminal.
3. After a successful firmware upload, type atgo to restart the VES.
The VES is now reinitialized with a default configuration file including the default password of "1234".
Please see the section about uploading the default configuration file for information on uploading the default
configuration file using CI commands.
Introducing the SMT
Menu 23 - System Password
Old Password= ?
New Password= ?
Retype to confirm= ?
Enter here to CONFIRM or ESC to CANCEL:

Figure 14-5 Menu 23.1 - System Password

VES-1000 Series Ethernet Switch
14-5