Changing The System Password; Figure 14-4 Ves-1012 Main Menu; Table 14-2 Main Menu Summary - ZyXEL Communications VES-1000 Series User Manual

VES-1000 Series Ethernet Switch
Getting Started
Advanced Applications
The following table shows the VES-1000 Series switch Main Menu summary:
# MENU TITLE
1 General Setup
2 Switch Setup
3 IP Setup
6 Port Setup
12 Static Routing Setup
17 VLAN Setup
22 SNMP Configuration
23 System Password
24 System Maintenance
99 Exit

14.6 Changing the System Password

It's important to change the default system password by doing the following:
Enter 23 from the main menu. This will open Menu 23 – Change Password as shown next.
1.
Type the existing system password ("1234" is the default password when shipped), then press [ENTER].
2.
14-4
Copyright (c) 1994 - 2002 ZyXEL Communications Corp.
VES-1012 Main Menu (VDSL_1)
1. General Setup
2. Switch Setup
3. IP Setup
6. Port Setup
12. Static Routing Setup
17. VLAN Setup

Figure 14-4 VES-1012 Main Menu

Table 14-2 Main Menu Summary

Use this menu to enter VES administrative information.
Use this menu to set the switch parameters, including STP setup, GARP timers
and QS parameters.
Use this menu to set up TCP/IP parameters such as the IP address, subnet mask
and default gateway.
Configure your VDSL and Ethernet ports in this menu including individual port
STP configuration.
Use this menu to set up static routes.
Configure switch VLAN setup in this menu.
Use this menu to set up SNMP related parameters
Use this menu to change your system password.
Configure menus for System Status, System Information/Console Port Speed,
Log and Trace, Diagnostic, Backup, Restore, Firmware Update, Command
Interpreter Mode, Time and Date Setting, Remote Management Control and
Hardware Monitor here.
To exit a system configuration/management session via SMT you must type 99.
You then return to a blank screen.
Advanced Management
22. SNMP Configuration
23. System Password
24. System Maintenance
99. Exit
DESCRIPTION
Introducing the SMT