Alamo Industrial Traxx RF Operator's Manual page 148

2. Remove the Tension Valve Inspection Plate
from the side of the undercarriage.
3. There may be a a plug installed at the end of
the grease valve. If there is a plug, remove it.
4. The special fittings will be in the box that
contained the remote.
5. Install the grease gun on the specialized fitting.
6. Pump the grease gun until a pressure of
1850psi is obtained.
7. Remove the grease gun and replace the
Tension Valve Inspection Plate.
TRAXX RF 04/14
© 2014 Alamo Group Inc.
MAINTENANCE
Maintenance Section 5-4