Setting The Mower; Cutting Height Adjustment - Alamo Industrial Traxx RF Operator's Manual

7. SETTING THE MOWER

Properly setting the cutting height is essential for efficient and safe operation. A properly set mower will make
a more uniform cut, distribute clippings more evenly, require minimal tractor work, and follow the contour of
uneven terrain. NOTE: Avoid very low cutting heights, striking the ground with the blades gives the most
damaging shock loads and will cause damage to the mower and drive. Blades contacting the ground may
cause objects to be thrown out from under the mower deck. Always avoid operating the mower at a height
which causes the blades to contact the ground. OPS-U- 0010
Never work under the Implement, the framework, or any lifted
component unless the Implement is securely supported or blocked up
to prevent sudden or inadvertent falling which could cause serious
injury or even death.

7.1 Cutting Height Adjustment

Loosen the front bolt (1) and remove the rear roller
mount bolts on both sides. Lower the rear bolt
location to raise the height.
7.2 Skid Shoe Height Adjustment
Adjust the Skid Shoe (2) so that it is at least 1/2"
from the ground when the roller is supporting the
mower.
Do not let the Blades turn when the Mower Deck is raised for any
reason, including clearance or for turning. Raising the Mower deck
exposes the Cutting Blades which creates a potentially serious hazard
and could cause serious injury or even death from objects thrown from
the Blades.
TRAXX RF 04/14
© 2014 Alamo Group Inc.
OPERATION
(SG-14)
(SRM-07)
Operation Section 4-13