Alamo Industrial Traxx RF Operator's Manual page 140

Included in tow accessory kit:
12mm x 100mm hex head capscrew
Standard flatwasher for 12mm bolt
Standard nut for a 12mm bolt
Assemble the nut and then the washer to the bolt.
Thread the bolt down most of the way to the head
of the bolt.
Locate a steel plate, approximately 1/2" thick by 3"
wide, with a length of 25cm. (Plate Included in tow
kit)
Drill a 13mm hole in the plate at the approximate
center to accept the 12mm hexhead capscrew,
washer and nut.
Install the hexhead capscrew into the manual
brake release hole until it bottoms out in the hole.
TRAXX RF 04/14
© 2014 Alamo Group Inc.
OPERATION
Operation Section 4-34