Changing Temperature Scale; Memory Mode - Braun WelchAllyn ThermoScan PRO 4000 User Manual

6021360_PRO4000_S4-46 Seite 8 Montag, 20. August 2007 8:46 08

Memory mode

The last temperature taken before the Braun ThermoScan is turned
off is stored in its memory and will be automatically displayed when
it is turned on again. The display will show «MEM». For longer
display of the stored measurement, the thermometer must be turned
on and the «I/O» button must be pressed for at least 1 second. The
memory mode is left automatically after pressing the «I/O» button
for at least 1 second.
Changing the temperature scale
Your Braun ThermoScan is shipped with the Fahrenheit temperature
scale activated. If you wish to switch to Celsius «°C», proceed as
follows:
Make sure the thermometer is turned off.
Press and hold down the «I/O» button. After about 3 seconds the
display will show this sequence: «°F» / «SET» / «°C» / «SET» ...
Release the «I/O» button when «°C» is shown.
There will be a short beep to confirm the new setting, then the
thermometer is turned off automatically. When turned on again,
temperatures will be shown in Celsius, until the above procedure is
repeated.
... ...
Base station for storage, charging,
anti-theft function (optional)
For your Braun ThermoScan PRO 4000, there is a Base Station
available. Contact your distributor for details (see page 14).
The station automatically recharges the thermometer (when using the
rechargeable batteries supplied with the base station), and it has an
electronic, individually adjustable anti-theft function. It also serves
as a convenient storage base (can be wall mounted).
It requires returning the thermometer to the station within an individ-
ually pre-selected time. Otherwise the thermometer will be locked.
When leaving the factory, the anti-theft function of the PRO 4000 is
turned off.
If the anti-theft function is enabled, and when not in the measur-
ing process (stand-by mode) the thermo-meter will show the hours
remaining before it is locked.
To turn on the anti-theft function, please refer to the base station
manual.
8