Advertisement
This thermometer is a high quality product incorporating the latest technology and tested in accordance with international standards. With its unique technology, the product can provide a stable, accurate reading with each measurement. The thermometer performs a self-test every time it is switched on to always guarantee the accuracy of measurements. The Braun No touch + forehead thermometer (NTF3000) is a non-sterile, reusable, clinical thermometer, intended for the intermittent determination of human body temperature on people of all ages in a touch and no touch mode using the center of the forehead as the measurement site.
Please read these instructions carefully before using this product and keep the instructions and the thermometer in a safe place.
Keep out of reach of children under 12 years. Never use the thermometer for purposes other than those for which it has been intended. Please follow the general safety precautions when using on children.
Never immerse the thermometer into water or other liquids (not waterproof). Please follow the instructions in the "Care and cleaning" section.
Do not store this thermometer in temperature extremes below -13°F (-25°C) or over 140°F (60°C) or in excessive humidity (above 95% non-condensing relative humidity). If thermometer is stored in a location that is cooler or warmer than where it is being used, let it sit in the patient's room for 10 minutes before taking a measurement.
Do not use the thermometer if there are signs of damage on the scanner or on the thermometer itself. If damaged, do not attempt to repair the product. Never insert a sharp object into the scanner area or any other open surface on the thermometer.
This thermometer consists of high-quality precision parts. Do not drop the device. Protect it from severe impact and shock. Do not twist the device or the sensor.
This thermometer is intended for household use only. Use of this thermometer is not intended as a substitute for consultation with your physician.
Temperature elevation may signal a serious illness, especially in newborns and infants, or in adults who are old, frail, or have a weakened immune system. Please seek professional advice immediately when there is a temperature elevation and if you are taking temperature on:
This thermometer is not intended for pre-term babies or light-for-date babies.
This thermometer is not intended to interpret hypothermic temperatures. Do not allow children below 12 years to take their temperatures unattended.
Please consult your doctor if you see symptoms such as unexplained irritability, vomiting, diarrhea, dehydration, changes in appetite or activity, seizure, muscle pain, shivering, stiff neck, pain when urinating, etc., even in the absence of fever.
Even in the absence of fever, those who exhibit a normal temperature may still need to receive medical attention. People who are on medication should not be assessed solely on temperature readings to determine the severity of their illness.
Do not modify this equipment without the authorization of the manufacturer.
Measurement in under 2 seconds
The innovative infrared technology measures forehead temperature in under 2 seconds, whether you use the touch or no-touch option.
Accurate and reliable
Due to the unique technology, the Braun No touch + forehead thermometer captures the heat naturally given off by the forehead to calculate temperature. Get the same professional accuracy whether touching your child's forehead with the thermometer or holding it up to 2 inches (5 cm) away.
Easy to use
The Braun No touch + forehead thermometer is non-invasive. A measurement can be taken even while a child is sleeping.
The Braun No touch + forehead thermometer is less threatening to a child than a rectal thermometer and easier to use than other methods.
Safe and hygienic
No-touch option helps minimize spreading of germs.
Safe for use on children and adults.
The Braun No touch + forehead thermometer measures infrared energy radiated from the skin at the center of the forehead area. This captured energy (which is twice as much thermal energy compared to a traditional forehead thermometer2 ), is collected through the sensor and converted to an oral equivalent temperature value.
The Braun No touch + forehead thermometer has been clinically tested and proven to be safe and accurate when used in accordance with its operating instruction manual.
Temperature guidance helps you to better understand the meaning of your child's temperature with the color indicated on the display. The screen displays a green, yellow, or red backlight depending on the temperature reading. 10 audible beeps indicate temperatures above 99.4F (37.4C).
It is important to note that a patient's temperature may be impacted by age, gender or medical condition, or by factors such as ambient temperature, time of day, medications taken or the temperature measurement site3.
Color range | Reading |
Green | >96.3 - 99.4°F (>35.7 - 37.4°C) |
Yellow | >99.4 - 101.3°F (>37.4 - 38.5°C) |
Red | >101.3 - 108.0°F (>38.5 - 42.2°C) |
NOTE: Backlight remains OFF when below temperature readings are registered: 93.9≤T≤ 96.3°F (34.4 ≤ T ≤ 35.7°C)
It is important to know each individual's normal temperature when they are well. This is the only way to accurately diagnose a fever. To determine normal temperature, take multiple readings when healthy. Re-measure with a standard digital thermometer for confirmation. This thermometer displays an oral equivalent temperature reading. Oral readings are approximately 0.9°F (0.5°C) lower than a rectal digital measurement4).
Patient must be inside for 30 minutes before taking a measurement. Note: Patient and the thermometer should be in the same ambient temperature for at least 10 minutes before taking a reading.
Always hold the thermometer and the forehead steady when taking a reading. Do not move the thermometer until you hear the final beep.
For patients measuring their own temperature, use the "touch" option instead of "no touch."
Don't take a measurement while or immediately after nursing a baby.
Patients should not drink, eat, or be physically active before/while taking the measurement. Remove hats and wait 10 minutes before taking a reading.
Remove dirt or hair from the forehead before taking a measurement. Bangs may cause higher readings. Wait at least 10 minutes after washing the forehead area before taking a reading.
Always take the temperature exactly as directed. Temperature results may vary if positioned in the wrong location.
In the following situations it is recommended that three temperatures in the same location be taken and the highest one taken as the reading:
The Braun No touch + forehead thermometer allows you to silence the beeps on the thermometer to avoid waking a sleeping child. To use this feature, slide the switch to the silent mode position and take a temperature reading. An icon will appear on the screen to show that the thermometer is in silent mode.
The thermometer is initially calibrated at the time of manufacture. If this thermometer is used according to the use instructions, periodic re-adjustment is not required. If at any time you question the accuracy, please contact Consumer Relations.
The thermometer should be cleaned in between uses, as necessary. Use an alcohol swab or cotton swab moistened with alcohol (70% Isopropyl) to clean the thermometer casing and the measuring probe. Ensure that no liquid enters the interior of the thermometer. Never use abrasive cleaning agents, thinners or benzene for cleaning and never soak the device in water or other cleaning liquids. Wait 10 minutes after cleaning before taking a temperature measurement. Make sure to replace the protective cap after use to prevent scratches or damage to the thermometer.
Never insert a sharp object into the scanner area or any other open surface on the thermometer.
Clean sensor mirror before each use or as needed.
The Braun No touch + forehead thermometer comes with 2 AA batteries. Replace with 2 new AA batteries when the flashing battery symbol appears on the LCD display. To change the batteries, slide open the battery cover and remove batteries. Replace the batteries being sure to align properly as indicated inside the battery compartment. Remove the battery from the product if it is not required for extended periods of time in order to avoid damage to the thermometer resulting from a leaking battery.
To protect the environment, dispose of the product and empty batteries at appropriate collection sites.
Error Message | Situation | Solution |
When 20% of battery life is left, the display flashes the low battery warning symbol. The device can still work until the battery life has 0% left. | Replace battery. | |
If the steady battery icon is the only symbol shown on the display, the device cannot work. The battery should be replaced immediately. | Replace battery. | |
This message displays when measured temperature is lower than 93.9°F (34.4°C) or higher than 108°F (42.2°C) or when the room temperature is outside the operating range of 59°F-104°F (15°C-40°C). | Make sure the protective cap is removed. Re-measure the temperature again, carefully following the instruction in "How to use" section. | |
Blank display. Thermometer does not have power. | Please check if the battery has been loaded correctly. Also check polarity (<+> and <–>) of batteries. Contact Consumer Relations if thermometer still does not function. |
You should first read all Instructions before attempting to use this product.
Call us toll-free at 1-800-477-0457 or e-mail: consumerrelations@kaz.com. Please be sure to specify a model number.
NOTE: IF YOU EXPERIENCE A PROBLEM, PLEASE CONTACT CONSUMER RELATIONS FIRST OR SEE YOUR WARRANTY. DO NOT RETURN THE PRODUCT TO THE ORIGINAL PLACE OF PURCHASE. DO NOT ATTEMPT TO OPEN THE MOTOR HOUSING YOURSELF, DOING SO MAY VOID YOUR WARRANTY AND CAUSE DAMAGE TO THE PRODUCT OR PERSONAL INJURY.
Type: | No touch + forehead thermometer (NTF 3000) |
Measuring range: | 93.9°F (34.4°C) – 108°F (42.2°C) |
Resolution: | 0.1°F (0.1°C) |
Laboratory Accuracy | ± 0.4°F for the range 95°-107.6°F (± 0.2°C for 35-42°C) (Ambient Temperature: 59°F to 104°F (15°C to 40°C ) |
Display: | Liquid Crystal Display, 4 digits plus special icons |
Acoustic: | Green backlight = single long beep for 2 sec duration |
Audio: | Red or Yellow backlight: 10 short beeps |
Operating temperature: | 59°F – 104°F (15°C – 40°C) |
Automatic Switch-off: | Approx. 60 seconds after last measurement has been taken |
Weight: | 3.51oz. (with battery), 2.72oz. (w/o battery) |
Long term storage ranges | |
Storage/transport temperature: | –13°F to 140°F (–25°C to 60°C) |
Humidity: | 15–95% non condensing |
Battery: | (2) AA Batteries - at least 1000 measurements |
Pressure: | 700-1060hPA (0.7-1.06 atm) |
This infrared thermometer meets requirements established in ASTM Standard E 1965-98 for the thermometer system. Full responsibility for the conformance of the product to the standard is assumed by Kaz, USA, Inc., a Helen of Troy Company, Marlborough, MA 01752, USA.
ASTM laboratory accuracy requirements for the thermometer only in the display range of 96.8°F to 102.2°F (36°C to 39°C) for infrared thermometers is ± 0.4°F (± 0.2°C), whereas for mercury-in-glass and electronic thermometers, the requirement per ASTM Standards E 667-86 and E 1112-86 is ± 0.2°F ( ± 0.1°C).
This device conforms to the following standards:
IEC 60601-1:2006 Medical electrical equipment. General requirements for basic safety and essential performance
ISO 80601-2-56 Particular requirements for basic safety and essential performance of clinical thermometers for body temperature measurement ASTM 1965E – ASTM Standard for Infrared Clinical Thermometers
EN 12470-5: 2003 «Clinical thermometers» – Part 3: Performance of compact electrical thermometers (non-predictive and predictive) with maximum device.
IEC 60601-1-2: General requirements for basic safety and essential performance – Collateral Standard: Electromagnetic compatibility – Requirement and tests
NOTE: Do not use this device in the presence of electromagnetic or other interference outside the normal range specified in IEC 60601-1-2.
EN 980: 2008 Symbols for use in labeling of medical devices.
EN 1041: 2008 Information supplied by the manufacturer of medical devices.
EN 60601-1-11: 2010 Medical electrical equipment -- Part 1-11: General requirements for basic safety and essential performance -- Collateral standard: Requirements for medical electrical equipment and medical electrical systems used in the home healthcare environment.
Contact Us
Questions or Comments?
Call us toll-free at: 1 800 477-0457
E mail: consumerrelations@kaz.com
Or visit our website at: www.braunthermometers.com
Please be sure to specify the model number.
This product is manufactured under license to the 'Braun' trademark.
'Braun' is a registered trademark of Braun GmbH, Kronberg, Germany.
© 2016 All Rights Reserved
Kaz, USA, Inc., a Helen of Troy Company
Marlborough, MA 01752
Patents: www.kaz.com/patents/braun
Made in China
P/N: 31IMNTF3190R1
07JUN16
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download Braun NTF 3000 No touch + Forehead Thermometer Manual
Advertisement
Thank you! Your question has been received!
Need Assistance?
Do you have a question about the NTF 3000 that isn't answered in the manual? Leave your question here.