Jumper Settings For Electh-Hpump And He-Hg; Setup And Operations; Product Overview; Description Of Function Keys - Z-Wave ZTS-110 User Manual

Jumper Settings for ELECTH-HPUMP and HE-HG

There are 6 jumpered pins on the thermostat circuit
board that identify whether your system is:
- Gas or electric heater
- Non-heat pump or heat pump system
You must ensure that these pins are set correctly for
your system. The pin location is shown in the following
diagram which is located at back side of ZTS-110.
Jumper
Set to ELECTH for non-heat pump system (Default)
ELECTH
- When there is a heating request, thermostat will turn on W1
- When there is a cooling request, thermostat will turn on Y
HPUMP
Set to HPUMP for heat pump system
ELECTH
- When there is a heating request, thermostat will turn on Y and B
- When there is a cooling request, thermostat will turn on Y and O
HPUMP
HG
Set to HG for Gas heat-fan controlled unit (Default)
Fan will maintain off state.
HE
HG
Set to HE for Electrical heat-fan controlled unit
Fan will be turned on when there is heating output.
HE
Note:
The HE and HG jumper controls the Fan when set to Auto in heating mode.
If user selects Fan ON at thermostat, the Fan will be turned on without considering the
HE-HG jumper selection.
Function Description
9

Setup and Operations

Product Overview

Figure 8. ZTS-110
Event mode
Day
MO
Time
PROG ON
FAN ON
Program mode Fan mode

Description of Function Keys

Symbol
Increase value / Toggle selection
Decrease value / Toggle selection
Select fan mode; also the Backward function key in some menus
Change operation mode; also the Forward function key in some
menus
Select program mode:
PROG ON, OVERRIDE and PERMANENT OVERRIDE;
also the Confirm function key in some menus
Back to Home
Inclusion indication Battery low indication
WAKE
AM
1
HEAT
Current temperature
Key Description
10
Mode