Set New Recipe (Using A Recipe Card) - Bunn Single SH BrewWISE DBC Installation And Operating Manual

PROGRAMMING THE BREWER (cont.)
SET NEW RECIPE
Using a RECIPE CARD to load coffee names and
brew settings into the SINGLE SH DBC with Smart
Funnel:
The G92T DBC or MHG's memory contains certain
coffee names. If the operator uses a coffee name that is
not already stored in the grinder's memory, a RECIPE
CARD can be obtained from the factory. The RECIPE
CARD would include all the information needed to
set up that particular coffee name. The information
from the RECIPE CARD is loaded into the grinder's
memory, then into the brewer's memory by holding
the recipe card up to the equipment's sensing coil.
This information can include the coffee name, BREW
VOLUMES, BYPASS PERCENTAGES, PULSE BREW
TIMES and DRIP-OUT TIMES for that particular coffee
NAME. These can all be loaded in seconds.
Contact Bunn-O-Matic Corporation for the avail-
ability of RECIPE CARDS.
NOTE: Instructions to program the brewer and grinder
are printed on the RECIPE CARD, along with the coffee
name that is being programmed.
Procedure to program the coffee name:
1. Remove the funnel (if present) from the funnel
rails.
2. Position the RECIPE CARD vertically, so that the
top end of the chip is beneath the funnel sensing
coil.
3. After a short pause the display will read CARD CON-
TAINS RECIPE FOR then will change to (COFFEE
NAME) SHOW QUIT SAVE. All brewing parameters
for that coffee name are now transferred from the
CARD to the brewer.
4. To show (view) this information, press and release
SHOW. The display will scroll through all of the
brew settings for all three batch sizes. The display
will then return to CARD CONTAINS RECIPE FOR
then will change to (COFFEE NAME) SHOW QUIT
SAVE.
5. If all brew settings are correct, press SAVE. The
display will read (COFFEE NAME) SETUP COM-
PLETE. All brew settings for that name are now
stored in the brewer's memory.
6. If the brewing information is not correct, or it is
desired to exit the setup before the settings are
loaded into the brewer's memory, press QUIT. The
display will read (COFFEE NAME) NOT SAVED. The
display will then return to the MAIN SCREEN.
READY TO BREW
WATER TEMP: 200º
POSITION CARD UNDER
CARD CONTAINS
(COFFEE NAME)
SHOW QUIT SAVE
SCROLLS THROUGH ALL
OF THE BREW SETTINGS
FOR THE THREE BATCH
SIZES FOR THAT COFFEE
NAME
(COFFEE NAME)
Page 19
SENSOR COIL
RECIPE FOR
(COFFEE NAME)
SETUP COMPLETE
NOT SAVED
P2440
34025.2 071105