Programming The Brewer; Program Functions (Level 1) Brew Lockout - Bunn Single SH BrewWISE DBC Installation And Operating Manual

The programming of the brewer is divided into two levels. There is one function in Level 1. All other functions
are accessed in Level 2.
The following function screens are in order of appearance. Each screen will have instructions on how to
access, and the procedures to program the various functions of the brewer.
To exit the programming mode at any time, press and release the switch located on the front switch panel.
The display will return to the MAIN SCREEN.
If none of the five programming switches are pressed within one minute during the setup of the brewer,
the programming of the function screen that is being set will be exited and the display will return to the MAIN
SCREEN.
Always remember to place a container and funnel under the sprayhead when operating the brewer during the
set-up of PULSE BREW, CALIBRATE FLOW and testing the brew and bypass valves in SERVICE TOOLS/TEST
OUTPUTS.
MAIN SCREEN
READY TO BREW
WATER TEMP: 200°
This screen will be shown when the brewer is ready
for use. The screen displays the water temperature
in the tank. When the water in the tank reaches the
correct set temperature, the display will change from
HEATING to READY TO BREW.
PROGRAMMING LOCKOUT SWITCH (mounted on
main control board)
This switch can be set to prevent access to the
programming levels of the brewer. Once all the cor-
rect brew settings are programmed, the operator can
set the switch to the "DISABLE" position to prohibit
anyone from changing the settings.
PROGRAM
PROGRAMMING
SWITCH

PROGRAMMING THE BREWER

IMPORTANT PROGRAMMING NOTES
- READ CAREFULLY -
PROGRAM FUNCTIONS - LEVEL 1
P2424
Page 11
BREW LOCKOUT
This function allows the operator to prevent or
allow brewing if the water temperature is less than
the set READY temperature.
To access this function screen press and hold the
Upper Right Hidden Switch. Release the switch when
the display reads:
BREW LOCKOUT?
NO DONE
Press here Press here
for NO for DONE
The YES or NO should be flashing. Select YES to
prevent brewing if the water temperature is below the
set READY temperature. Select NO to permit brewing
at any water temperature.
When finished, press and release DONE. This
will exit this function screen and return to the MAIN
SCREEN on the display.
YES
Press here
for YES
34025.2 071105