Using A Handset As A Room Monitor - Siemens Gigaset S685 IP User Manual

Using several handsets
If the internal participant does not answer
or the line is busy, press the display key
to return to the external call.
§End§
When transferring a call you can also press
the end call key a before the internal
participant answers.
Then, if the internal participant does not
answer or the line is busy, the call will
automatically return to you (the display
will show Recall).
Initiating internal consultation call,
conference call
You are talking to an external participant
(via fixed line network or VoIP) and can
call an internal participant at the same
time to hold a consultation call.
u
Open the list of handsets.
The external participant hears
hold music if activated
(page 97).
s
Select handset and press
When an internal participant answers you
can speak to them.
You have the following options:
Ending a consultation call
Press the display key.
§End§
You are reconnected with the external
participant.
Initiating a conference call
Press the display key.
§Conf.§
You are in a three-way conference call
with the external participant and the inter-
nal participant.
If the internal participant who has been
called ends the call (press end call key
a), you will be connected with the
external participant. If you press end call
key a, the external call will be trans-
ferred to the internal participant.
84
Accepting/rejecting call waiting during
an internal call
If you receive an external call during an
internal call, you will hear the call waiting
tone (short tone). With Calling Line Identi-
fication, the caller's number will appear in
the display.
Ending an internal call, accepting an
external call
§Accept§
The internal call is ended. You are con-
nected to the external caller.
Rejecting the external call
§Reject§
The call waiting tone is turned off.
You remain connected with the internal
participant. The ringer tone can still be
heard on other registered handsets.
Using a handset as a
.
§OK§
room monitor
If the room monitor is activated, a previ-
ously stored destination number is called
as soon as a set noise level is reached in
the room.
You can save an internal or external
number in your handset as the destination
number.
The room monitor call to an external
number stops after around 90 seconds.
The room monitor call to an internal
number (handset) stops after approx. 3
minutes (depending on the base station).
During use as a room monitor, all keys are
barred except for the end call key a. The
speaker of the handset is muted.
When the room monitor is activated,
incoming calls to the handset are indi-
cated without a ringer tone and are only
shown on the screen. The display and key-
pad are not illuminated and advisory
tones are also turned off.
Press the display key.
Press the display key.