Using A Handset As A Room Monitor - Siemens Gigaset C59H Manual

Using a handset as a room monitor

Using a handset as a
room monitor
If the room monitor is activated, a previously
saved destination number is called as soon
as a set noise level is reached. You can save
an internal or external number in your hand-
set as the destination number. All of the
handset keys are deactivated, with the
exception of the display keys.
The room monitor call to an external
number is terminated after approximately
90 seconds. The room monitor call to an
internal number (handset) stops after
approx. 3 minutes (depending on the base).
When the room monitor is activated, all keys
are locked except the end call key. The hand-
set's speaker is muted.
When the room monitor is activated, incom-
ing calls to the handset are indicated with-
out a ringtone and are only shown on the
screen. The display and keypad are not illu-
minated and advisory tones are also turned
off.
If you accept an incoming call, the room
monitor is suspended for the duration of the
call, but the function remains activated.
If you deactivate then reactivate the hand-
set, the room monitor remains activated.
36
Warning!
u
Always check the operation of
the room monitor before use.
For example, test its sensitivity.
If you are diverting the room moni-
tor to an external number, check the
connection.
u
When the function is switched on, the
handset's operating time is considera-
bly reduced. If necessary, place the
handset in the charging cradle. This
ensures that the battery does not run
down.
u
Ideally position the handset 1 to
2 metres away from the baby.
The microphone must be directed
towards the baby.
u
The connection to which the room
monitor is diverted must not be
blocked by an activated answering
machine.
Activating the room monitor and
entering the destination number
É
¢ ¢
v
Room Monitor
¤
You can enter data in the following fields:
Activation:
Select On to activate.
Alarm to:
Select Internal or External.
External number: Select the number
from the directory (press display key
or enter it directly.
Internal number: Select display key
¢
Select handset or Call All if
§Change§
you want to call all registered handsets
¢
§OK§
.
In idle status, the destination number or
the internal destination number is dis-
played.
¤
§Save§
Press to save the settings.
ö
)