Table of Contents
Advertisement
Gigaset SX670_SX675 isdn / EN-Master / A31008-xxxx-xxxx-x-xxxx / registr_sett.fm / 7.11.07
ten if this handset is in idle status. You can
change the internal number of all regis-
tered handsets (1–6).
u
§Options§
Edit H/Set No.
s
~
§Save§
a
You will hear the error tone (descending
tone sequence) if you assign an internal
number twice.
¤
Repeat the procedure with a free
number.
Using a handset as a
room monitor
If the room monitor is activated, a previ-
ously saved destination number is called
as soon as a set noise level is reached. You
can save an internal or external number in
your handset as the destination number.
The room monitor call to an external
number stops after around 90 seconds.
The room monitor call to an internal
number (handset) stops after approx. 3
minutes (depending on the base station).
When the room monitor is activated, all
keys are locked except the end call key.
The handset's speaker is muted.
When the room monitor is activated,
incoming calls to the handset are indi-
cated without a ringer tone and are only
shown on the screen. The display and key-
pad are not illuminated and advisory
tones are also turned off.
52
Open list of handsets. Your
own handset is indicated by <.
Open menu.
Select and press
. The list of
§OK§
handsets is displayed.
The current number flashes.
Select a handset.
Enter the new internal number
(1–6). The handset's old
number is overwritten.
Press the display key to save
the input.
Press and hold (idle status).
If you accept an incoming call, the room
monitor mode is suspended for the dura-
tion of the call, but the function remains
activated.
If you deactivate then reactivate the hand-
set, the room monitor mode remains acti-
vated.
Warning!
– You should always check the operation
of the room monitor before use. For
example, test its sensitivity. Check the
connection if you are diverting the room
monitor to an outside number.
– When the function is switched on, the
handset's operating time is severely
reduced. If necessary, place the handset in
the charging cradle. This ensures that the
batteries do not run down.
– Ideally the handset should be positioned 1
to 2 metres away from the baby. The micro-
phone must be directed towards the baby.
– The connection to which the room monitor
is diverted must not be blocked by an acti-
vated answer machine.
Activating the room monitor and
entering the number to be called
¢
¢
v
í
Room Monitor
¤
Change multiple line input:
Room M.:
Select
On
to activate.
Call to:
External number: Select the number
from the directory (press display key
Ò
) or enter it directly.
Internal number:
§Options§
¢
¢
s (select handset or
§OK§
if all registered handsets are to be
¢
called)
.
§OK§
Level:
Set noise level sensitivity
¤
Press
to save the settings.
§Save§
Changing the set destination number
¢
¢
v
í
Room Monitor
s
Scroll to the
¢
INT
Call All
(Low
or High).
line.
Call to:
Advertisement
Table of Contents
