Appendix; Care; Contact With Liquid; Questions And Answers - Siemens Gigaset S685 IP User Manual

Appendix

Appendix

Care

¤
Wipe down the base station and hand-
set with a damp cloth (no solvents) or
an antistatic cloth.
Never use a dry cloth. This can cause
static.

Contact with liquid

If the handset should come into contact
with liquid:
¤
Switch the handset off and remove
the batteries immediately.
¤
Allow the liquid to drain from the hand-
set.
¤
Pat all parts dry, then with the battery
compartment open and the keypad fac-
ing down place the handset in a dry,
warm place for at least 72 hours (not
in a microwave, oven etc.).
¤
Do not switch on the handset again
until it is completely dry.
When it has fully dried out, you will nor-
mally be able to use it again.

Questions and answers

If you have any questions about using
your phone, visit us at www.siemens.com/
gigasetcustomercare at any time. The
table below contains a list of common
problems and possible solutions.
136
!
Please note:
To support the service team, it can be helpful if
you have the following information to hand:
– Version of firmware, EEPROM and your
phone's MAC address
You can check this information with the
Web configurator (page 135). For how to
display the MAC address on your handset,
turn to page 102.
– VoIP status code (page 140)
For problems with VoIP connections, you
should set VoIP status messages to be dis-
played on your handset (page 100,
page 132). These messages contain a sta-
tus code that helps when the problem is
analysed.
Registration or connection problems with a
Bluetooth headset.
¥
Reset the Bluetooth headset (see the user
guide for your headset).
¥
Delete registration data from the handset
when de-registering the device
(see page 94).
¥
Repeat the registration process
(see page 94).
The display is blank.
1. The handset is not switched on.
¥
Press and hold the end call key
2. The battery is flat.
¥
Charge the battery or replace it
(page 10).
The keys of a handset do not respond when
pressed.
The keypad lock is activated.
¥
Press and hold the hash key
(page 31).
"Base X" flashes on the display.
1. The handset is outside the range of the
base station.
¥
Move the handset closer to the base
station.
2. The handset has been de-registered.
¥
Register the handset (page 81).
3. The base station is not turned on.
¥
Check the base station's mains adapter
(page 13).
4. The base station firmware is currently being
updated (page 98/page 132).
¥
Please wait until the update is complete.
a
.
#