Table of Contents
Advertisement
Recorder
Configuration and
Hardware Setup
This section provides information on how to configure the VNM Recorder so that it will
work within a VN-Matrix system. After completing this chapter, see
Web‑based User Interface
VNM Recorder using a control PC.
Topics that are covered include:
•
•
•
•
•
•
Setup Overview
1.
2.
3.
4.
5.
6.
7.
on page 23 for information about controlling the
Setup Overview
VNM Recorder Power Up Procedure
VNM Recorder Power Down Procedure
Choosing the Controller Device
Configuring the VNM Recorder
Configuring the VN‑Matrix Encoders and Decoders
Connect a mouse, a keyboard, and a computer monitor (for configuration purposes) to
the VNM Recorder (see
Rear Panel Features
Use a network switch to connect a primary VN-Matrix network to the rear panel
Ethernet connector (
) of the VNM Recorder (see
eth0
Power on the VNM Recorder and all necessary devices (see
Up Procedure
on page 13).
Determine the device that will function as the controller (see
Device
on page 16).
Configure the VNM Recorder network settings (see
VNM Recorder
on page 17).
Configure the network settings of each VN-Matrix encoder and decoder (see
Configuring the VN‑Matrix Encoders and Decoders
Power down the VNM Recorder (see
page 15) and all configured devices. After a few seconds, power on the
VNM Recorder and all necessary devices.
VNM Recorder • Recorder Configuration and Hardware Setup
About the
on page 10).
Rear Panel
VNM Recorder Power
Choosing the Controller
Configuring the
on page 22).
VNM Recorder Power Down Procedure
Features).
on
12
Advertisement
Table of Contents
