Configuration And Hardware Setup; Setup Overview - Extron electronics VNR 100 User Manual

Configuration and
Hardware Setup
This section provides information on how to perform the initial configuration of the VNR 100
so that it will work over the Ethernet with a network that is controlled by an Enterprise
Controller. Topics that are covered in this section include:
•
•
•
•
•
•

Setup Overview

NOTE: if the VNR 100 recorder is rack mounted, access to the rear panel may be
1.
2.
3.
4.
5.
6.
Setup Overview
VNR 100 Power Up Procedure
VNR 100 Power Down Procedure
Initial Configuration of the VNR 100
Getting Started with the Enterprise Controller
Creating Still Frames from a VN-Matrix Video Recording
restricted. Connect all cables at the same time as the unit is mounted.
Mount the VNR 100 recorder in a suitable location (see
page 22).
Connect a standard IEC power cord to the rear panel power connector
page 8).
Connect the VNR 100 to a network, using the rear panel Ethernet port 0 (figure 5,
The VNR 100 must be controlled by an VNM Enterprise Controller connected to the
network.
Power on the VNR 100 (see
Use a computer on the same network as the VNR 100 to carry out the initial
configuration (see Initial Configuration of the VNR 100
This initial configuration makes the VNR 100 available to a VNM Enterprise Controller on
the same network.
If it becomes necessary to power down the VNR 100 recorder, see
Down Procedure on the following page.
Mounting the VNR 100
VNR 100 Power Up Procedure
VNR 100 • Configuration and Hardware Setup
on
5,
(figure
A
G
on the following page).
on the following page).
VNR 100 Power
on
).
11