Emergency Operation; Miscellaneous Settings - Panasonic S-200PE1E8 Technical Data & Service Manual

8-13. Emergency Operation

Use [Emergency Operation]
• When the remote control's batteries have failed.
• When the remote control is broken.
• When the remote control is lost.
1. Press [Emergency Operation]
If the indoor temperature is 24°C or greater when the unit starts running,
it will act as a cooler.
If the indoor temperature is less than 24°C when the unit starts running,
it will act as a heater.
2. If you press , the wind direction automatically oscillates up and down.
Stop: press [Emergency Operation]
NOTE
• The Test Run/On and Test/On switches are for use when the unit is installed and test run. It is not for normal
use.
• If the [Normal/Stop ALL] switch is on Stop ALL , the unit cannot receive signals from the remote control.

8-14. Miscellaneous Settings

A variety of changes can be made to settings, depending on the indoor unit being used.
Wind direction (flap) indicator, operation mode indicator, time display (24 hour, AM/PM), heat max temp
• For information about the flap function, refer to the users' manual of the unit being used.
• (These settings are saved in nonvolatile memory in the remote control, so even when its batteries are changed,
the settings do not have to be made again.)
• First check the display of the remote control when the unit is stopped and then make any desired settings.
How to Operate
• While holding down the buttons below, every time
• Whatever is being displayed when you release
Setting Item
Remote control flap display
setting for when
is pressed
Remote control operation
mode display setting when
is pressed
Clock display setting
Max possible temperature
setting in the Heat mode
in the following situations when there is an urgent need.
of the receiver
of the receiver again.
Operation Button
Models with movable flaps
Press
Swing only models
while pressing
Models w/o lamps
Heat Pump (with Auto)
Press
Heat Pump (without Auto)
while pressing
Dedicated air conditioner
Press 24 Hour
while pressing AM/PM
Maximum heating
Press
temperature
while pressing
range is 26°C – 30°C
8-9
is pressed the remote control's display changes.
is set.
Setting Content
CZ-RWSC2
1
2
Remote Control Display
N o n e
8