Optional Controller (Remote Controller); Names And Functions - Panasonic S-200PE1E8 Technical Data & Service Manual

Optional Controller (Remote Controller)

Wireless Remote Controller / CZ-RWSC2
One remote control can control a group of up to eight indoor units.

8-3. Names and Functions

REMOTE CONTROLLER
1. Operation Display Displays the operation status.
(The figure shows all the statuses.)
2. Start/Stop Pressing this button once starts and
pressing again stops the operation.
button
The auto-flap display may be
different, depending on the installed
unit.
3. Fan speed
button
4. Swing/Wind
Direction button
5. Timer setting Use for operating with a timer.
button
6. Reset button Use this button after changing the
batteries.
7. Cover Press at the top center and then slide
down.
8. Transmitter
9. Remote control Detects the temperature at the remote
controller when detection has been
sensor
switched to the remote control by the
sensor button.
10. Temperature
setting buttons
11. Filter button Press to turn off the filter lamp on the
receiver.
12. Mode Select Press to switch the operation mode.
button
13. Ventilation Use this when connected to an
aftermarket fan. Pressing this button
button
starts and stops the fan. When the air
conditioner is started or stopped, the
fan starts or stops at the same time.
(
remote control when the fan is
operating.)
14. Address
button
raises the temperature setting
1 at a time.
lowers the temperature setting
1 at a time.
appears on the display of the
15. Sensor button Use this when switching to detect the
temperature at the remote control. At
shipping the default setting is set to
detect the temperature at the unit. At
this time
16. Clock button Use this when setting the clock.
1
2
3
4
5
6
7
From this page on the names of remote control
buttons will be abbreviated as the illustration of the
"button".
E.g.: Start/Stop button
8-3
is shown on the display.
8
9
10
11
12
13
14
15
16
8