Yaesu FT-991 Operating Manual page 90

cw c
onvenience
t M p
ext eSSAge rogrAMMing
1. Press the MODE button to set the operating mode to
CW.
Break-in is "Off" with [ BK-IN ] on the
2. Be sure that
LCD, if necessary.
3. Touch [ MEM ] on the LCD or press the FH-2 [ MEM ]
key. A blinking "REC" icon will appear in the dis-
play.
4. Touch [ CH1 ] - [ CH5 ] on the LCD or press an FH-2
[ 1 ] - [ 5 ] key to select the desired CW Memory Reg-
ister into which you wish to program the text. The
text input screen will appear.
5. Touch a key on the LCD to enter the letters, num-
bers, or symbols of the desired label.
6. Repeat step 5 to program the remaining letters, num-
bers, or symbols of the desired text. 12 characters
may be used in the creation of a text.
Use [  ] and [  ] on the LCD to set the cursor posi-
tion and [ ] on the LCD to erase a letter at the left
of the cursor.
7. When you have completed the creation of the text,
touch [ ENT ] on the LCD.
Page 88
f
eatures
c M
onteSt eMory
A
dvice
Use the FH-2 [  ] and [  ] keys to set the cursor posi-
tion and use the FH-2's [  ] and [  ] keys to choose
the letter/number to be programmed in each slot of the
memory. In the case of the second example on the previ-
ous page the "#" character designates the slot where the
Contest Number will appear.
8. When the message is complete, add the "}" character
9. Touch [ MEM ] on the LCD or press and hold in the
c
hecking the
1. Be sure that Break-in is still turned "Off" with [ BK-
2. Touch [ MONI ] on the LCD to enable the CW moni-
3. Touch [ CH1 ] - [ CH5 ] on the LCD or press an FH-2
k
eyer
:
at the end to signify the termination of the message.
FH-2 [ MEM ] key for one second to exit, once all
characters (including "}") have been programmed.
cW M c
eMory ontentS
IN ] on the LCD.
tor.
[ 1 ] - [ 5 ] key, whichever memory you just recorded
in. You will hear the results in the sidetone, but no
RF energy will be transmitted.
FT-991 O M
peraTing anual