Keyboard Frequency Entry; Setting With The Multi Knob - Yaesu FT-991 Operating Manual

c
onvenience
M

Keyboard Frequency Entry

The Operating frequency may be entered directly into
the current VFO, using the display screen keyboard by
pressing the front panel BAND button.
Example: Enter 14.250.00 MHz
1. Press the BAND button to begin the direct frequency
entry process.
2. Touch [ ENT ] on the LCD. The first digit of the fre-
quency (the leftmost digit) will blink.
3. Enter, in order, the digits of the operating frequency,
touching the keys on the LCD
The decimal point after the "MHz" portion of the
frequency must be entered, but no decimal point is
required after the "kHz" portion.
4. Touch [ ENT ] on the LCD once more to complete
the operating frequency entry. A short "beep" will
confirm that the entry was successful, and the new
operating frequency will appear on the display.
A :
dvice
If you attempt to enter a frequency outside the oper-
ating range of 30 kHz - 56 MHz, the microprocessor
will ignore the attempt, and will return to the previ-
ous operating frequency. If this happens, please try
again, taking care not to repeat the error in the fre-
quency entry process.
Page 42
f
eatures
F n
ore requency
t
AvigAtion echniqueS

Setting with the MULTI Knob

Rotate the MULTI knob to set the frequency in the pre-
programmed frequency steps. The frequency step can be
changed.
1. Press the F(M-LIST) button to display the function
menu list. Touch the [ CH DIAL ] icon to activate this
function and cause the MULTI knob to function as
the frequency adjustment knob.
CH-D (CH DIAL) indicator
2. Touch [ CH DIAL ] to select the desired frequency
step. Touching [ CH DIAL ] switches the frequency
as follows.
o M
perAting ode
AM
SSB/CW/RTTY/
DATA-LSB/DATA-USB
FM/C4FM/
DATA-FM
3. Rotate the MULTI knob to change the frequency in
the selected frequency steps.
FT-991 O
F S
requency tep
2.5  5  9  10  12.5  25 
2.5  ...
1  2.5  5  1  ...
5  6.25  10  12.5  15  20
 25  5  ...
M
peraTing anual