Headlamp Main/Dipped-Beam; Flash-To-Pass - Cadillac 2015 SRX Owner's Manual

The IntelliBeam system can be
disabled by the Main/dipped
beam Changer or the
Flash-to-Pass feature. If this
happens, the Main/dipped beam
Changer must be activated two
times within five seconds to
reactivate the IntelliBeam
system. The instrument cluster
light will come on to indicate the
IntelliBeam is reactivated. See
Headlamp Main/dipped beam
Changer on page 6-3 or
Flash-to-Pass on page 6-3.
The main beams may not turn off
automatically if the system cannot
detect another vehicle's lamps
because of any of the following:
The other vehicle's lamps are
missing, damaged, obstructed
from view, or otherwise
undetected.
The other vehicle's lamps are
covered with dirt, snow, and/or
road spray.
The other vehicle's lamps cannot
be detected due to dense
exhaust, smoke, fog, snow, road
spray, mist, or other airborne
obstructions.
The vehicle's windscreen is dirty,
cracked, or obstructed by
something that blocks the view
of the light sensor.
The vehicle is loaded such that
the front end points upward,
causing the light sensor to aim
high and not detect headlamps
and tail lamps.
Driving on winding or hilly roads.
The main beam headlamps may
need to be disabled if any of the
above conditions exist.
This feature can be turned on or off
in vehicle personalisation. See
Vehicle Personalisation on
page 5-39.
Lighting
Headlamp Main/
Dipped-Beam Changer
Push the indicator lever away from
you and release to turn the main
beams on. To return to dipped
beams, push the stalk again or pull
it toward you and release.
This indicator light turns on in the
instrument cluster when the
high-beam headlamps are on.

Flash-to-Pass

The flash-to-pass feature works with
the dipped beams on or off.
To flash the main beams, pull the
indicator lever all the way toward
you, then release it.
6-3