Cadillac 2015 SRX Owner's Manual page 306

11. Press the on/off button (2) to
turn the tyre sealant and
compressor kit off.
The tyre is not sealed and will
continue to leak air until the
vehicle is driven and the
sealant is distributed
in the tyre, therefore,
Steps 12 18 must be done
immediately after Step 11.
Be careful while handling the
tyre sealant and compressor kit
as it could be warm after
usage.
12. Unplug the power plug (8) from
the accessory power outlet in
the vehicle.
13. Turn the sealant/air hose (6)
anticlockwise to remove it from
the tyre valve stem.
14. Replace the tyre valve
stem cap.
15. Replace the sealant/air hose
(6), and the power plug (8)
back in their original location.
16. If the flat tyre was able to
inflate to the recommended
inflation pressure, remove the
maximum speed label from the
sealant canister (5) and place it
in a highly visible location. Do
not exceed the speed on this
label until the damaged tyre is
repaired or replaced.
17. Return the equipment to its
original storage location in the
vehicle.
18. Immediately drive the vehicle
8 km (5 mi) to distribute the
sealant in the tyre.
Vehicle Care
19. Stop at a safe location and
check the tyre pressure. Refer
to Steps 1 11 under Using the
Tyre Sealant and Compressor
Kit without Sealant to Inflate a
Tyre (Not Punctured).
If the tyre pressure has fallen
more than 68 kPa (10 psi)
below the recommended
inflation pressure, stop driving
the vehicle. The tyre is too
severely damaged and the tyre
sealant cannot seal the tyre.
If the tyre pressure has not
dropped more than 68 kPa
(10 psi) from the recommended
inflation pressure, inflate the
tyre to the recommended
inflation pressure.
20. Wipe off any sealant from the
wheel, tyre and vehicle.
21. Dispose of the used sealant
canister (5) and sealant/air
hose (6) assembly at a local
dealer or in accordance with
local regulations and practices.
10-61