Cadillac 2015 SRX Owner's Manual page 323

10-78 Vehicle Care
To tow the vehicle from the front
with all four wheels on the ground:
1. Position the vehicle that will be
towed and secure it to the
towing vehicle.
2. Open the driver door.
3. With the vehicle OFF, press the
brake pedal and press the
START/STOP button to start the
engine (the green indicator lamp
on the button will illuminate).
4. Put the vehicle in N (Neutral).
5. Press the START/STOP button
again. The engine will stop, the
DIC will display SHIFT TO
PARK, and the amber indicator
lamp on the switch illuminates.
See Transmission Messages on
page 5-38.
6. Remove the following fuses:
ESCL, BCM 1, BCM 2 and BCM
3. The START/STOP button
indicator lamps will be off. See
Instrument Panel Fuse Block on
page 10-36.
7. Close the driver door.
Caution
If the vehicle is towed without
performing each of the steps
listed under Dinghy Towing, the
automatic transmission could be
damaged. Be sure to follow all
steps of the dinghy towing
procedure prior to and after
towing the vehicle.
Caution
If 105 km/h (65 mph) is exceeded
while towing the vehicle, it could
be damaged. Never exceed
105 km/h (65 mph) while towing
the vehicle.
Once the destination has been
reached:
1. Apply the parking brake.
2. Reinstall the fuses. See
Instrument Panel Fuse Block on
page 10-36.
3. Shift the transmission to
P (Park).
4. Place the ignition position to
LOCK/OFF.
5. Disconnect the vehicle from the
tow vehicle.
6. Start the engine and let it idle for
more than three minutes before
driving the vehicle.