Cadillac 2015 SRX Owner's Manual page 256

1. Cover Cut Outs
2. Air Filter Tabs
To inspect or replace the engine air
cleaner/filter:
1. Open the bonnet. See Bonnet
on page 10-3.
2. Locate the air filter housing on
the front of the passenger side
of the engine compartment. See
Engine Compartment Overview
on page 10-5.
3. Disconnect the outlet duct by
loosening the air duct clamp (1).
4. Disconnect the electrical
connector (2). First, remove the
connector lock clip located at the
bottom of the connector, then
press on the top and bottom of
the connector to remove.
5. Lift the 3 retaining clips (3) on
the air filter housing.
6. Tilt and lift the cover slightly
upwards and slide the cover
away from outside edge of the
vehicle. Remove the air filter.
7. To install the air filter, place filter
inside box where the pleats fit in
between the tabs located inside
the lower box. Ensure that the
cover cut outs (1) on both sides
match the air filter tabs (2) on
both sides.
8. Replace air cleaner cover by
inserting the 4 tabs into the 4
slots. Lower cover to meet
bottom of box. Place the 3
retaining clips (3) on retention
features and clip closed.
Vehicle Care
9. Reconnect outlet duct to cover
and tighten the air duct
clamp (1).
10. Reconnect the electrical
connector (2). Install connector
lock clip to bottom of
connector.
Warning
Operating the engine with the air
cleaner/filter off can cause you or
others to be burned. The air
cleaner not only cleans the air; it
helps to stop flames if the engine
backfires. Use caution when
working on the engine and do not
drive with the air cleaner/filter off.
10-11