Exterior Lamps Off Reminder; Headlamp Main/Dipped-Beam; Changer; Flash-To-Pass - Cadillac XT4 2023 Owner's Manual

114 Lighting
Driving with IntelliBeam
The system only activates the main beams
when driving over 40 km/h (25 mph).
The blue main-beam on light appears on the
instrument cluster when the main beams
are on.
There is a sensor near the top centre of the
windscreen that automatically controls the
system. Keep this area of the windscreen
clear of debris to allow for best system
performance.
The main beam headlamps remain on, under
the automatic control, until one of the
following situations occurs:
The system detects an approaching
vehicle's headlamps.
The system detects a preceding vehicle's
tail lamps.
The outside light is bright enough that
main beam headlamps are not required.
The vehicle's speed drops below 20 km/h
(12 mph).
The IntelliBeam system is disabled by the
button on the indicator Lever. If this
happens, press the button on the end of
the indicator lever when the exterior
lamp control is in the AUTO or
position to reactivate the IntelliBeam
system. The instrument cluster light will
come on to indicate the IntelliBeam is
reactivated.
The main beams may not turn off
automatically if the system cannot detect
another vehicle's lamps because of any of
the following:
The other vehicle's lamps are missing,
damaged, obstructed from view,
or otherwise undetected.
The other vehicle's lamps are covered
with dirt, snow, and/or road spray.
The other vehicle's lamps cannot be
detected due to dense exhaust, smoke,
fog, snow, road spray, mist, or other
airborne obstructions.
The vehicle's windscreen is dirty, cracked,
or obstructed by something that blocks
the view of the light sensor.
The vehicle is loaded such that the front
end points upward, causing the light
sensor to aim high and not detect
headlamps and tail lamps.
The vehicle is being driven on winding or
hilly roads.
The automatic main beam headlights may
need to be disabled if any of the above
conditions exist.

Exterior Lamps Off Reminder

A warning chime sounds if the driver door is
opened while the ignition is off and the
exterior lamps are on.

Headlamp Main/Dipped-Beam

Changer

: Push the indicator lever away from
you and release, to turn the main beams on.
To return to dipped beams, push the stalk
again or pull it toward you and release.
This indicator light turns on in the
instrument cluster when the high-beam
headlamps are on.

Flash-to-Pass

To flash the main beams, pull the indicator
stalk toward you, and release.