Table of Contents
Advertisement
MAINTENANCE
INSTRUCTIONS
! CAUTION:
BEFORE
PERFORMING
ANY MAINTENANCE
TO YOUR TREADMILL
ALWAYS
UNPLUG
THE POWER
CORD
FROM THE SURGE
PROTECTOR,
WALKING
BOARD
LUBRICATION
INSTRUCTIONS
"[he walking belt has been pre-lubed at the factory. However it is recommended for optimal performance, the
walking board be checked periodically for lubrication.
Every 30 days or after 30 flours of operation raise the
sides of the walking belt, and feel the top surface of the walking board as far under the belt as you can reach.
If you feet signs of silicone, then no further lubrication is required. If, however the walking board surface feels
dry to the touch, additional lubrication should be applied, We recommend, for lubrication you use NAPA 8300
which is available through NAPA Auto Parts Slores, or Pyroil Silicone Lubricant which is available in most
stores,
TO APPLY LUBRICATE TO THE WALKING BOARD:
1.
Position the walking belt so that the seam is located on top and in the center of walking board.
2.
Insert spray nozzle into spray head of lubricant can.
3.
While lifting the edge of walking belt, position the spray nozzle between walking belt and walking board
approximately 6" from the front of the treadmill. Apply silicone lubricant to the walking board moving from
front to rear of treadmill.
Note: SprR, y time should not exceed four seconds.
Repeat for other side of
walk-
. ing board.
WARNING:
DO NOT over lubricate
the walking board.
Any excess lubricant,
should.be.
, wiped off irhmediately.
Be careful not to spray' silicone lubricant iiiside the motor
compartment.
4.
"The silicone should dry for approximately one minute before using the treadmill.
earn
Approx,
6"
20
Hide quick links:
Advertisement
Table of Contents
