Table of Contents
Advertisement
Heart Rate Control Operating Instructions (8800 Only)
HEART RATE PROGRAM MODE
*
Plug into a standard wall outlet (110 Volt AC, 15 amp circuit)
•
Place the Heart Rate transmitter strap across chest against the skin Stand on the treadmill and straddle belt.
*
Press POWER button.
There will be an eight (8) second delay after pressing the POWER button before data can be
entered. The TIME window will flash. The ■Heart" shape on the treadmill will be flashing
if
the Heart Rate Transmitter is
transmitting. Adjust the strap on the chest until the console is picking up a signal.
•
For Quick Start, press START/STOP button. Belt will begin to move after 4 seconds. Step on belt slowly after Ihe belt starts
moving. Speed or incline may be adjusted by using the appropriate + (increase) or - [decrease) buttons. Heart rate will read
out in the Incline window.
*
To select the Heart Rate Control program, press the "Heart Hate Control" button.
•
You can now program the Time, Speed, and Heart Rate. The time window will blink. Use the SPEED/TIME + or -
arrows to select your workout time, then press the ENTER PROGRAM button. The SPEEDfTIME window will now
be flashing. Using the same + or - arrows, select the maximum speed for your workout, then press ENTER
PROGRAM. Now the INCLINE window will be Hashing. Use the TARGET + or - arrows to set your target heart rate,
then press ENTER PROGRAM. To start, press Ihe START/STOP button.
Maintenance Instructions
The Keys treadmills are equipped with MAINTENCANCE-FREE DECKS.
LUBRICATION IS NOT REQUIRED!
The treadmill deck is a specialized waxed surface/lamnate material that is maintenance free. There are no re-wax
products available and the deck cannot be re-waxed.
Arty attempt to lubricate the treadmill deck will void the
warranty.
CLEANING
Routine cleaning of your Keys treadmill win extend the life of your treadmill. WARNING! To prevent electrical
shock, be sure the power to the treadmill is OFF and the unit unplugged from the wall electrical outlet before
attempting any cleaning or maintenance.
AFTER EACH WORKOUT. Wipe off the console and other treadmill surfaces with a clean, water dampened soft
cloth to remove excess perspiration. USE NO CHEMICALS.
WEEKLY: Use of a treadmill mat is recommended for ease of cleaning. Dirt from your shoes contacts the belt and
eventually makes it to underneath the treadmill. Vacuum underneath treadmill once a week.
DO NOT CLEAN OR WIPE UNDERNEATH THE BELT!
As mentioned above, the deck is lubricated
14
Advertisement
Table of Contents
