E590-8003; E747-051B - Canon imagePRESS C7000VP Series Trouble Shooting Information

1.18 E590-8003

 Description
The punch motor brake control varies depending on the type of connected punch unit. If the
dipswitch setting does not match the punch unit connected, the error code 'E590-8003'
appears.
- E590-8003 can be displayed when a punch motor brake error occurs.
 Field Remedy
1. Check the type of connected punch unit.
2. If the connected punch unit is Punch Unit-V1, turn on Bit2 of DIP SW 381 on the optional
switch PCB on the finisher.
Reference:
Regarding other punch units set the appropriate Bit(s) of DIP SW381 as follows:
Punch Unit-U1 (2-hole): turn Bit1 ON

Punch Unit-V1 (2/3-hole): turn Bit2 ON

Punch Unit-W1 (4-hole: FRANCE): turn Bit 1 and 2 ON

Punch Unit-X1 (4-hole: SWEDEN): turn Bit3 ON


1.19 E747-051B

 Description
Since the S-B PCB was faulty, the error code 'E747-051B' was indicated when copies or
printouts were output after this machine had started up. When the same symptom occurs, go
through the following steps in sequence.
- E747-051B can be displayed when an error occurs in the main controller PCB (MAIN-M).
 Field Remedy
1. Turn the main power switch OFF and then ON.
2. If the symptom still occurs, turn the main power switch OFF and clean the terminals of the
following boards, which are piggybacked on the main controller PCB, with lint-free paper
moistened with alcohol; then re-fit the boards.
RO-B PCB

O-B PCB (when an EFI controller is connected) or GU-Short PCB (when an EFI

controller is not connected)
S-B PCB

ZJ-A PCB (piggybacked on the S-B PCB)

LAN-BAR-B PCB

RB-A PCB (w/REOS function, included in the PDL option)

1. If the symptom still occurs, replace the S-B PCB with a new one.
2. If the symptom still occurs, replace the main controller PCB (MAIN-M) with a new one.
3. If the symptom still occurs, replace all the boards listed in Step 2 except the S-B PCB
by new ones.
FM2-7813 Main Controller PCB Assembly, M
FM2-9076 S-B PCB Assembly
Trouble Shooting Information for C7000VP series
Page 19
Rev. 2.0
2010/09/17