Canon imagePRESS C7000VP Series Trouble Shooting Information page 10

 Field Remedy
In order to deal with this malfunction, the DC controller software has been updated to Ver.12.04.
When the same symptom occurs, check the software version, if it is earlier than Ver.12.04,
upgrade to Ver.12.04 or higher.
As a difference case, the warm gear at the rear side
may get onto the engaging gear. In such a case,
rotate the warm gear in counter clockwise to ease
this state.
< Case 3 > E018-0102
 Description
There are some reported instances from the field where the machine was restored from
E018-0102 after cleaning the edge registration detect assembly. When the same symptom
occurs, go through the following steps in sequence.
- E018-0102 is displayed when the edge registration patch sensor causes shutter-related
error.
 Field Remedy
1. If the side scraper (FL2-2025) in the edge registration detect assembly has been soiled like
[1]; clean it, then turn the main power switch OFF/ON.
If the symptom still occurs, clean or replace the 30T/63T gear [2] (FU6-0381), the 60T gear
[3] (FU6-0382) and the 60T gears [4] (FU6-0383, 3 pc) that drive the shutter, then turn the
main power switch OFF/ON.
4. If the symptom still occurs, replace the edge registration detect sensor with a new one.
FU6-0381 30T/63T Gear
FU6-0382 60T Gear
FU6-0383 60T Gear
FM2-2156 Edge Registration Detect Assembly
Rotate the gear by hand
Trouble Shooting Information for C7000VP series
Page 10
Rev. 2.0
2010/09/17