Canon imagePRESS C7000VP Series Trouble Shooting Information page 116

 Adjusting the Position of Punch Holes of a Custom Paper Type
1. Press [Change] next to <Hole Punch Position Adjust>.
2. Press either of triangles to adjust the position of punch holes > [OK].
Depending on the paper type, the positions of the punch holes may be slightly different on each
piece of paper. In this case, you can make fine adjustments to the positions of the punch holes
to compensate this error. For example, if the positions of the punch holes on multiple paper
types in the Sheet Insertion mode are not exactly the same, you can use this mode to make fine
adjustments.
Increasing the setting value will shift the positions of the punch holes down toward the

bottom.
Decreasing the setting value will shift the positions of the punch holes up toward the

top.
Trouble Shooting Information for C7000VP series
Page 116
Rev. 2.0
2010/09/17