Retained Accessory; Power (Rap); Shifting Into Park - Cadillac 2015 Escalade Owner's Manual

Hide thumbs Also See for 2015 Escalade:
Table of Contents

Advertisement

9-22
Driving and Operating
try, to allow the cranking motor
to cool down. When the engine
starts, let go of the button, and
the accelerator. If the vehicle
starts briefly but then stops
again, do the same thing. This
clears the extra petrol from the
engine. Do not race the engine
immediately after starting it.
Operate the engine and
transmission gently until the oil
warms up and lubricates all
moving parts.

Retained Accessory

Power (RAP)

The following vehicle accessories
can be used for up to 10 minutes
after the engine is turned off:
Audio System
Power Windows
OnStar System (if equipped)
Sunroof (if equipped)
Accessory Power Outlets. The
console and centre seat sockets
are RAP powered.
These features work when the
ignition is in ON/RUN or ACC/
ACCESSORY. Once the ignition is
turned from ON/RUN to LOCK/OFF,
the windows and sunroof continue
to work up to 10 minutes until any
door is opened. The radio continues
to work for up to 10 minutes or until
the driver door is opened.

Shifting Into Park

Warning
It can be dangerous to get out of
the vehicle if the shift lever is not
fully in P (Park) with the parking
brake firmly set. The vehicle can
roll. If you have left the engine
running, the vehicle can move
suddenly. You or others could be
injured. To be sure the vehicle will
not move, even when you are on
Warning (Continued)
fairly level ground, use the steps
that follow. If the vehicle has a
four-wheel drive transfer case
with a N (Neutral) position, and
the transfer case is in N (Neutral),
the vehicle will be free to roll,
even if the shift lever is in
P (Park). Be sure the transfer
case is in a drive gear. If towing a
trailer, see Driving Characteristics
and Towing Tips on page 9-69.
1. Hold the brake pedal down, then
set the parking brake.
See Parking Brake on
page 9-34.
2. Move the shift lever into the
P (Park) position by pulling the
shift lever toward you and
moving it up as far as it will go.
3. Be sure the transfer case is in a
drive gear
(Continued)
4. Turn the ignition to LOCK/OFF.
not in N (Neutral).

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents