Cadillac 2015 Escalade Owner's Manual page 191

6-2 Lighting
AUTO (Automatic): Automatically
turns the exterior lamps on and off,
depending on outside lighting.
(Parking Lamps): Turns on the
parking lamps including all lamps,
except the headlamps.
(Headlamps): Turns on the
headlamps together with the parking
lamps and instrument panel lights.
When the headlamps are turned on
while the vehicle is on, the
headlamps will turn off automatically
10 minutes after the ignition is
turned off. When the headlamps are
turned on while the vehicle is off,
the headlamps will stay on for
10 minutes before automatically
turning off to prevent the battery
from being drained. Turn the
headlamp control to off and then
back to the headlamp on position to
make the headlamps stay on for an
additional 10 minutes.
®
IntelliBeam System
If equipped, this system turns the
vehicle's main beam headlamps on
and off according to surrounding
traffic conditions.
The system turns the main beam
headlamps on when it is dark
enough and there is no other traffic
present.
This light comes on in the
instrument cluster when the
IntelliBeam system is enabled.
Turning On and Enabling
IntelliBeam
To enable the IntelliBeam system,
with the indicator lever in the neutral
position, turn the exterior lamp
control to AUTO. The blue main
beam on light appears on the
instrument cluster when the main
beams are on.
Driving with IntelliBeam
The system only activates the main
beams when driving over 40 km/h
(25 mph).
There is a sensor near the top
centre of the windscreen, which
automatically controls the system.
Keep this area of the windscreen
clear of debris to allow for best
system performance.
The main beam headlamps remain
on, under the automatic control,
until one of the following situations
occurs:
The system detects an
approaching vehicle's
headlamps.
The system detects a preceding
vehicle's tail lamps.
The outside light is bright
enough that main beam
headlamps are not required.