Hazard Lights; Turn And Lane-Change; Signals - Cadillac 2015 Escalade Owner's Manual

6-6 Lighting

Hazard Lights

(Hazard Warning Indicators):
Press this button to make the front
and rear indicator lamps flash on
and off. Press again to turn the
flashers off.
When the hazard warning indicators
are on, the vehicle's indicators will
not work.

Turn and Lane-Change

Signals

An arrow on the instrument cluster
flashes in the direction of the turn or
lane change.
Move the indicator stalk all the way
up or down to signal a turn.
Raise or lower the stalk for less than
one second until the arrow starts to
flash to signal a lane change.
This causes the indicators to
automatically flash three times.
It will flash six times if Tow/Haul
Mode is active. Holding the indicator
lever for more than one second will
cause the indicators to flash until
the lever is released.
The stalk returns to its starting
position whenever it is released.
If after signalling a turn or a lane
change the arrows flash rapidly or
do not come on, a signal bulb could
be burned out.
Replace any burned out bulbs. If a
bulb is not burned out, check the
fuse. See Fuses on page 10-29.
Indicator On Chime
If the indicator is left on for more
than 1.2 km (0.75 mi), a chime
sounds at each flash of the
indicator. The message INDICATOR
ON will also appear in the Driver
Information Centre (DIC). To turn
the chime and message off, move
the indicator stalk to the off position.