Cadillac 2015 Escalade Owner's Manual page 187

5-54 Instruments and Controls
indicator light in view. The
hand-held transmitter was
supplied by the manufacturer of
the garage door opener receiver.
2. At the same time, press and
hold both the hand-held
transmitter button and one of the
three Universal Remote system
buttons to be used to operate
the garage door. Do not release
either button until the indicator
light goes from a slow to a rapid
flash light. Then release both
buttons.
Some entry gates and garage
door openers may require
substitution of Step 2 with the
procedure under Programming
for Some Gate Operators later
in this section.
3. Press and hold the newly
programmed Universal Remote
system button for five seconds
while watching the indicator light
and garage door activation.
If the indicator light stays on
continuously or the garage
door moves when the button
is pressed, then
programming is complete.
There is no need to complete
Steps 4 6.
If the indicator light does not
come on or the garage door
does not move, a second
button press may be
required. For a second time,
press and hold the newly
programmed button for
five seconds. If the light
stays on or the garage door
moves, programming is
complete.
If the indicator light blinks
rapidly for two seconds, then
changes to a solid light and
the garage door does not
move, continue with
programming Steps 4 6.
Learn or Smart Button
4. After completing Steps 1 3,
locate the Learn or Smart button
inside the garage on the garage
door opener receiver. The name
and colour of the button may
vary by manufacturer.
5. Press and release the Learn or
Smart button. Step 6 must be
completed within 30 seconds of
pressing this button.