Installing A New Satellite Pair - KVH Industries TracVision G6 Technical Manual

TracVision G6 Technical Manual
Figure 3-32
Install Satellite Pair Process
Install Satellite?
Enter
Install A <SAT NAME>
Yes
Install B <SAT NAME>
Yes
Installing sats
Please wait
<SAT Name> and
<SAT NAME> installed
Latitude:
-
Longitude:
-
86

Installing a New Satellite Pair

These screens are only seen if the GyroTrac ADCU is connected to a
TracVision G6.
TracVision G6 permits two satellite services (Satellites A and B) to
be installed simultaneously. There is also an option for NONE on
Satellite B, permitting single satellite operation.
Next Return
Proceed to "Setting Latitude
and Longitude"
Next Cancel
Selecting NEXT will cycle
the display through all
available satellites
Next Cancel
Selecting NEXT will cycle
the display through all
satellites that can be paired
with the selection for
Satellite A. If no satellite is
available for a pair or you
wish a single satellite
configuration, select NONE.
Refer to Tables 3-1 and
3-2 for available North
American and European
satellite pairs.
Enter your latitude. Use the -/+
keys to select each number and
##N
choose between NORTH and
Enter +
SOUTH. Selecting ENTER will
cycle the display through each
digit and the direction option and
then launch the LONGITUDE
screen.
Enter your longitude. Use the -/+
###E
keys to select each number and
Enter +
choose between EAST and
WEST. Selecting ENTER will cycle
the display through each digit and
the direction option and then
display the selected latitude and
longitude.
Latitude: ##N
Longitude: ####E
Restart antenna?
Yes No
Restart
Antenna
System
If a GPS is providing latitude and
longitude to TracVision G6, this
data will automatically be used in
the satellite installation procedure.
In this event, the menus will skip
directly to "Restart Antenna."
54-0161