Replacing The Antenna Gyro Assembly - KVH Industries TracVision G6 Technical Manual

TracVision G6 Technical Manual
Replacing the Antenna Gyro
Make sure the cable jacket passes
through the PCB access slot to
protect the wires from the edge of
the PCB frame.
112
5.5
1. Remove the PCB cover, as explained in "Removing
the PCB Cover" on page 108.
2. Remove the four screws, four washers, and the
counterweight from the end of the antenna gyro
(see Figure 5-6).
Figure 5-6
Assembly
Counterweight
3. Using a
standoffs securing the antenna gyro to the reflector
bracket (see Figure 5-6). Slide the tie-wrap, which
secures the antenna gyro cable, off the bottom
right standoff.
4. Remove the 3 tie-wraps securing the gyro cable to
the RF cables (see Figure 5-1 on page 107).
5. Disconnect the antenna gyro Molex connector
from the main PCB (see Figure 5-3 on page 109).
Remove the old antenna gyro assembly.
Replacing the Antenna Gyro
Assembly
Gasket
Gyro
Standoffs
3 ⁄ " nut driver/socket, remove the four
8
Bracket
54-0161