Selecting The Wash Programme; Starting The Wash Cycle - Hoover HNF 9167 Instruction Book

40002098Eng.qxd 22/11/2004

Selecting the wash programme

Starting the wash cycle

Press the
setting the wash parameters and then after a few seconds the wash
programme will begin. The display will then indicate the time to the end of
the cycle and the current phase of the cycle (i.e. washing, rinsing or spinning).
Do not try to open the door when the washing programme is in progress. The
screen will indicate when the door can be opened.
Do not open the dispenser drawer during the wash programme.
If you wish to pause the programme press the
you will be able to open the door. To cancel the programme please refer to
the 'Cancelling and changing the programme' section of this manual.
When the programme has finished
Wait approximately two minutes for the door lock to be released. When the
Inter@ct display indicates DOOR OPEN it will then be safe to open the door.
Switch off the machine by turning the programme selector to the OFF position
so that it will be ready the next time you use the machine (this action resets
the memory in the machine).
Open the door and remove the laundry.
Disconnect the plug from the mains power supply and turn off the water
supply whenever you finish using it.
34
11:35 Page 34
Refer to the Programme Guide or the programme
descriptions on the front of the machine to select
the most suitable programme.
The programme is selected by turning the
programme selector and aligning the programme
name with the indicator.
The programme will be displayed on the Inter@ct
3D screen, along with the standard spin speed and
the wash temperature for the selected programme.
Check that the tap is turned on and that the
discharge hose is positioned correctly.
Select the required wash options, including the
spin speed and wash temperature if you wish to
change these from the standard settings.
button. The Inter@ct 3D screen will indicate that the machine is
button; after two minutes