Using Inter@Ct 3D For The First Time - Hoover HNF 9167 Instruction Book

40002098Eng.qxd 22/11/2004
Using Inter@ct 3D for the
first time
This machine will operate even if you do not programme the Inter@ct set-up.
However, this machine has Start Delay and Programme Set End Time functions
and for these functions to work efficiently the Inter@ct 3D must be
programmed. This is a simple operation and special care has been taken
during manufacture to ensure that the user can operate this machine simply
and effectively.
Programming the machine
Inter@ct needs to be programmed so that the correct clock setting, language
and personal requirements are set. When the machine is turned on and the
programme dial is moved away from the OFF position to a programme
selection, a welcome message will appear:
00
This message is displayed for a short time while the machine recognises which
programme has been selected. When the machine is ready, the programme
details will appear on the display and from here you may now begin
programming the machine.
Example
Spin Speed
Please note that when using the Inter@ct menu you have 30 seconds per
operation to make your selection. Should you run out of time, the display will
11:34 Page 17
WELCOME!
COTTON WHITE
11
HEAVY SOIL
Programme
x100 selected
00
0:00
90
Temperature
(°C)
17