Selecting The Wash Programme; Starting The Wash Cycle - Hoover HI 148 Instruction Book

40002960Eng.qxd 12/04/2005 15:11 Page 33

Selecting the wash programme

Refer to the Programme Guide or the programme
descriptions on the front of the machine to select
the most suitable programme.
The programme is selected by turning the
programme selector and aligning the programme
name with the indicator.
The programme will be displayed on the Inter@ct
3D screen, along with the standard spin speed and
the wash temperature for the selected programme.
Check that the tap is turned on and that the
discharge hose is positioned correctly.
Select the required wash options

Starting the wash cycle

Press the Départ/Pause button. The Inter@ct 3D screen
will indicate that the machine is setting the wash
parameters and then after a few seconds the wash
programme will begin. The display will then indicate
the time to the end of the cycle and the current
phase of the cycle (i.e. washing, rinsing or spinning).
Do not try to open the door when the Porte
Sécurisée indicator is on.
Do not open the dispenser drawer during the
wash programme.
If you wish to pause the programme press the
Départ/Pause button and after 2 minutes the door
can be opened. To cancel the programme the Départ/
Pause button must be pressed down for 5 seconds.
A beep will then sound and the display will first
inform you that the programme has been paused and
then that it has been cancelled. A new programme
can be selected after cancelling the programme.
When the programme has finished
Wait for the door lock to be released. The Porte
Sécuriséee indicator will go out after approximately
2 minutes and then the door can be opened.
Switch off the machine by turning the programme
selector to the ARRÊT position before selecting the
next programme (this action resets the memory in
the machine).
Open the door. Remove the laundry.
Disconnect the plug from the mains power supply
and turn off the water supply after every use.
33