Table of Contents
Advertisement
About the Play Screen
The screen that appears after you turn on the power is called the Play screen.
Icons in the display
Left display
MASTER BPM
Bank – Number
Icon
Explanation
Displays the Master BPM (*1) value for each patch.
This is displayed when OUTPUT SELECT (p. 9) is set to anything other than LINE/PHONES.
This is displayed when OUTPUT SELECT (p. 9) is set to LINE/PHONES.
When the DIVIDER (p. 27) mode is Single, preamp channel "A" is selected.
When the DIVIDER (p. 27) mode is Single, preamp channel "B" is selected.
This is displayed if the DIVIDER (p. 27) mode is Dual.
This icon is highlighted if the SOLO SW (*1) is on.
,
,
This is displayed when the PHRASE LOOP (p. 18) is On.
*1 For the detail on the Master BPM and SOLO SW, download "GT-100 Parameter Guide" (PDF file) from "GT-100" in the "Owner's Manuals" list on the Roland website (http://
www.roland.com/support/en/).
Types of Play screens
Screen with the patch name shown large
Amp control screen (Ch . A)
Amp control screen (Ch . B)
Effect on/off status indication screen
OUTPUT SELECT setting
PREAMP Channel
PHRASE LOOP on
Use the PAGE [
][
] buttons to switch .
Right display
If DIVIDER (p . 27) is set to
SINGLE, only the screen of the
currently selected channel
(not both channels) will be
shown .
The explanations in this manual include illustrations that depict what
should typically be shown by the display.
Note, however, that your unit may incorporate a newer, enhanced version
of the system (e.g., includes newer sounds), so what you actually see in
the display may not always match what appears in the manual.
Panel Descriptions
21
Advertisement
Table of Contents
