Level Mower Deck - Ariens ZOOM 915055-1944 Owner's/Operator's Manual

1
2
1. Clamping Knob (915065, 067, 055,
057, 059) or flat washer and nut
(915501, 502)
2. Seat Tipped Forward
2
1. Hood Clip
2. Hood Tipped Open
Figure 10
• TO LOWER the mower deck, turn rear
trunnion counterclockwise several
Figure 9 OE0300
1
LEVELLING AND ADJUSTING
PITCH OF MOWER DECK
Adjust on a level surface, with the tires
inflated to the correct air pressure (see
SPECIFICATIONS on page 27).

Level Mower Deck

1. Install adjustment pin in the fourth
adjustment hole (figure 11).
1. Adjustment Pin
2. Rotate the right and left mower blades
until the ends of both mower blades are
facing rearward (figure 12).
NOTE: The rear blade cutting height should
be 2-7/8 to 3 in. (7.3 to 7.6 cm) from rear
edge of mower blades to the ground on both
blades (figure 12).
IMPORTANT: The distance from rear edge of
mower blades to the ground MUST NOT
exceed 3 in. (7.6 cm) (figure 12).
Mower Deck Shown
From The Side
1. Mower Deck
2. Mower Blade
3. Front of Mower
Deck
3. Measure from rear edge of mower
blades to the ground (figure 12).
4. Perform steps 5 through 7 if the
measurement is too high or too low on
either side of mower deck.
5. Remove rear lift link and rear trunnion
from mower deck and mower lift
(figure 13).
OE0140
• TO RAISE the mower deck, turn rear
trunnion clockwise several turns.
turns.
GB - 17
2
2. Mower Lift
Pedal
Figure 11
1
6
5
4. Front Blade
Cutting Height
5. Ground
6. Rear Blade
Cutting Height
Figure 12
1
OE0060
2
3
4
OE0010