Replacing Pto Belt - Ariens ZOOM 915055-1944 Owner's/Operator's Manual

5
1. Handlebar
2. Steering Lever
3. Mounting Hardware
4. Adjustment Holes
5. Eccentric Spacer
Figure 19
Forward and Reverse Speed
Adjustment
(Figure 20)
IMPORTANT: The unit should track within 2
feet (0.61 m) of a straight line for 30 feet
(9.14 m).
The travel of the steering levers may need
adjustment if:
• The unit turns to the right or left when
both steering levers are pushed as far
forward as possible.
• The unit turns to the right or left when
both steering levers are pulled back as
far rearward as possible.
1
NOTE: The side the unit turns toward
indicates that the wheel on that side is turning
slower than the other wheel. Either the wheel
that is turning faster needs to slow down or
the wheel that is turning slower needs to be
sped up to allow the unit to travel in a straight
line.
1. Determine which way the unit turns.
2. Tip seat forward (see TIPPING SEAT
FORWARD on page 16).
NOTE: The forward travel adjustment bolt
adjusts the forward travel of the steering
lever. The rear travel adjustment bolt adjusts
the rearward travel of the steering lever.
2
3. Adjust speed by:
3
• Turning adjustment bolt clockwise to
decrease steering lever travel.
• Turning adjustment bolt counter
clockwise to increase steering lever
travel.
4
1. Forward Travel Adjustment Bolt
2. Rear Travel Adjustment Bolt
3. Steering Lever

REPLACING PTO BELT

OE0046
Remove (Figure 21)
1. Lower mower deck to the ground.
2. Remove belt covers from mower deck.
CAUTION: Use care when releasing
idler spring tension. Keep body parts
well away from idler when performing
this operation.
GB - 22
2
1
Figure 20
3
OE0330